• Info-Hotline
    +61 1300 780 141

  • Weekdays
    8:00 to 5:00 PST

 

Diesel Power® and MultiMotion® Optimization Systems for Petrol Turbo Engines

More efficiency, more power, more torque, with reduced fuel consumption.
The premium class for your vehicle. State-of-the-art hardware, engine-specific tuning and a comprehensive service and safety package.

Diesel Power® and MultiMotion® optimization systems always correspond to the latest state-of-the-art technology for every vehicle, with the best quality and the best optimization options.
We do not offer cheaper optimization systems with reduced hardware quality and a poorer degree of optimization.

To meet the requirements of engines with Euro 6d ISC-FCM (Euro 6d Full) and Euro 7 "Ready" standards, we have developed a new generation of Diesel Power® and MultiMotion® electronics, specifically tailored, to optimize engines with integrated sensor monitoring.

All Diesel Power® and MultiMotion® optimization modules offered, have E1 approval (E110R06/029979* 00).

To meet the requirements of engines with Euro 6d ISC-FCM (Euro 6d Full) and Euro 7 "Ready" standards, we have developed a new generation of Diesel Power® and MultiMotion® electronics, specifically tailored, to optimize engines with integrated sensor monitoring.


We only use the highest quality “low voltage” components, which enables us to operate all Diesel Power® and MultiMotion® optimization systems with a supply voltage of 5 volts.
This makes installation considerably easier, as there is no need for a separate 12 volt connection and the entire electronic system is therefore significantly less prone to errors.

H.&N. Electronics GmbH possesses over 600 TÜV parts certificates, for more than 3000 vehicle types. However, providing TÜV parts reports for all vehicles, compatible with our optimization modules, may not be feasible.

As of January 1st, 2022, the TÜV parts report has been replaced by a part type approval / ABE requirement. The testing scope and documentation requirements for engines compliant, with Euro 6d ISC-FCM (Euro 6d Full) and Euro 7 "Ready" emissions standards, have expanded significantly, making obtaining a part type approval / ABE, economically feasible only in specific cases
(refer to traffic bulletin issue 8 – 2021, pages 409 – 415).

You can find out which vehicles have reports for them, using our configurator.

Can't find your car in our Chiptuning configurator ?
Then contact us !


Scops of delivery

  • DIESELPOWER Chiptuning
  • Specific adapter
  • Installation manuals
  • Protective and mounting case module
  • Bridge connector for the series output
  • 16 fine tuning mappings
  • TÜV parts certificate for your selection ( see configurator )

Illustration example
The wiring harness and the installation instructions may differ depending on the vehicle